Seidio Bluetooth GPS Receiver
RBT-1000 Quick Guide
Check the Package Content
Before you start using Seidio Bluetooth GPS Receiver, RBT-1000, please
check out if your package includes the following items. If any item is damaged
or missed, please contact your reseller at once.
ϥ RBT-1000
Power Switch, Power Jack & External Antenna Port
Right View
Power
Switch
External
Antenna Port
Power Jack
English
1
device. If the connection between your device and RBT-1000 is
successful, the Blue LED will be blinking.
2. Select correct bluetooth GPS device which name is BlueGPSXXXXXX
(see picture below).
STEP 4: Connect to your Navigation Software
Install and launch your navigation software in Navigation Software Kit and set
GPS configuration. Select correct COM port subject to the outbound
Bluetooth serial port of your handheld device and correct baud rate
depending on your navigation software.
•If you are required to type in pin code during configuration, please key in
“0000”.
How to replace Lithium-ion Battery
1. Open the bolt on the bottom cover of RBT-1000 and take the Lithium-ion
battery out.
2. Place new Lithium-ion battery into the room of RBT-1000.
Ϭʳ The RBT-1000 Lithium-ion battery is replaceable and
rechargeable.
Ϭʳ The RBT-1000 Lithium-ion battery can last more than 8 hours in
continuous operation mode.
How to use Car Charger to charge your handheld device
Connect car charger into your adapter connector of handheld device.
English
3
Tips
1. Place your RBT-1000 below the windshield without window film for car
navigation
2. It is suggested that use RBT-1000 under less shielded environment to
ensure better performance.
3. For the first position fix, please make sure your RBT-1000 is not in motion
but stationary and in open space so as to shorten the fix time.
English
4
|